2 photos
-
Bambu Lab PS1 3D Printer
4 photos
My latest 3D printer, a Bambu Labs PS1. Fast and noisy!
-
Shadecloth Clamp
2 photos
A shadecloth clamp I designed.
Based on a design in thingiverse.com which didn't quite work. -One change I made is spikes instead of ribs on the gripper bit.
Printed in PETG on my Bambulab PS1. -
Bird Feeder Extender
1 photo
At the top of this bird feeder is an extension I designed and printed. It doubles the seed capacity of the feeder.
Printed in "spiral vase" mode, 0.6mm wide clear PETG.
Came out surprisingly well. -
Gutter adapter
4 photos
This is a box gutter to pipe adapter.
Printed on my Bambulab PS1 in PETG.
The square end gets cut off. It was added for support. -
Chair Feet
1 photo
The protectors on the bottom of this chair were busted.
Downloaded a design for some from thingiverse.com. Too flimsy.
So I designed these thicker ones. (Pretty in pink.)
Printed on my Bambulab PS1 in PLA. -
Plant Pot Saucer
1 photo
I couldn't find a suitable saucer size on thingiverse.com, so I designed this one for Michele.
Now she can have saucers of any size she wants.
https://www.thingiverse.com/thing:6331052 -
Coffee Dripper Top
1 photo
This cap is to replace one lost from my one-cup coffee dripper.
Printed fine in black PETG.
Simple design done in Open SCAD. -
Voxelab Aquila X2 Printer
1 photo
My Voxelab Aquila X2 is a cheap decent 3D printer.
I added a direct drive hotend to allow TPU printing, which worked, and a PEI magnetic plate.
But it is now superseded by my new Bambulab PS1.